2004 Polaris Pro X Factory Service Manual, Page 285Get this manual
STEERING Toe AdjustmentEdge
7Hold tie rod and tighten jam nutsBe sure to position inner and outer tie rod ends parallel to their respective mounting surface as shownWhen tie rod ends are properly tightened, the tie rod should rotate freely approximately 18 turnMounting Surface Incorrect Correct Tie Rod End Support Edge
Tie Rod Jam Nut Torque 8-14 ftlbs(11-19 Nm)
Carbide to Ski Placement
A good starting point for placement of carbide is 5050 (50 forward and 50 behind the ski mounting bolt)This can be varied depending on the aggressiveness of the carbide and the strength of the driverMake sure the leading edge of the carbide has small chamferMore carbide trailing will cause the machine to track straighter, but steering effort will increase