2004 Polaris Pro X Factory Service Manual, Page 284Get this manual
STEERING Toe Adjustment- Edge
1Remove alignment bar from spindles2Toe alignment is set with shocks installed on Edge3Install skis4With the front of the machine still securely supported off the ground, install block or spacer between the rear of the ski frame and the bottom of the trailing armThe block should be 3.754.0 longThe blocks will keep ski-to-ground surface orientation correct for more accurate toe adjustment5Adjust toe so skiscarbides are parallelzero toe out or toe in with toe alignment travel bar installedMeasure from equal point on skag centerline to straightedge to determine the amount of adjustment required per skiMeasuring from points on skis may vary and should not be used