2004 Polaris Pro X Factory Service Manual, Page 242Get this manual
ENGINE 25Install water pump cover with new gasketWater Pump Cover Bolt Torque: Ft lbs (12.5 Nm) 26Install exhaust manifold with new exhaust manifold gasketsExhaust Manifold Bolt Torque: 16 Ft lbs (22 Nm) Seal Stator Wires Apply Loctitet 262 to Taper
27Install reed valves, stuffers, and carburetor adaptorsPlace stator wire guide on Mag side carburetor adaptor bolt28Install stator assembly, aligning timing marks or marks made upon disassemblySeal stator wires with high temperature silicone sealantInstall and tighten stator screws to specification29Measure trigger (pulse) coil gap and compare to specificationStator Screw Torque 60 inlbs(7 Nm) Trigger (Pulse) Coil Gap Minimum: .020 (.5mmMaximum: .040 (1.0mm )