2004 Polaris Pro X Factory Service Manual, Page 160Get this manual
CHASSIS Handlebar Torque and Sequence
1Remove the handlebar cover2Using 716 (11 mm) wrench, loosen four nuts on bottom of adjuster blockNOTE: Turn handlebar to left or right for access to back nuts3Adjust handlebar to the desired heightBe sure that handlebars, brake lever and throttle lever operate smoothly and do not hit the fuel tank, windshield or any other part of the machine when turned fully to the left or rightIMPORTANT: When adjusting the handlebar, be sure the serrations in handlebar and adjuster block match before torquing4Torque the handlebar adjuster block bolts to specification following sequence shownThe gap should be equal at front and rear5Replace the handlebar coverSeat Cover
3 Socket Screws 1
Handlebar Adjuster Block Bolt Torque 17 ftlbs(25 Nm)