2004 Polaris Pro X Factory Service Manual, Page 157Get this manual
FINAL DRIVE 10Reinstall clutch offset washers on jackshaft and install driven clutchUsing the clutch alignment tool adjust driven clutch to achieve proper offsetSee Clutch Offset Adjustment in this manualClutch Alignment Tool PN 9324895
P85 Offset 58P85 Electric Start Off-set: (straight edge)
11With proper offset achieved, the driven clutch must float on the jackshaftThis is done by adding or subtracting spacer washers (PN 7555734) to the clutch retaining boltWhen properly adjusted, the driven clutch will have .020.100 (.5 2.5 mm) floatCAUTION: Incorrect float can cause jackshaft bearings to be side loaded, resulting in premature bearing failure12Torque driven clutch retaining bolt to specificationDriven Clutch Retaining Bolt Torque 12 ftlbs(16.6 Nm)