2004 Polaris Pro X Factory Service Manual, Page 93Get this manual
CLUTCHING Spider Indexing NOTE: Spider indexing affects clutch balance and belt to
sheave clearanceRead procedures carefully before proceeding1Before disassembling drive clutch, mark spider, cover, moveable sheave, and stationary sheave in line with permanent marker as shown2Disassemble drive clutch as described starting on page 4.11Take care to note the amount and thickness of the shim washers under the spider
3Add or remove spider washers as required to achieve desired belt to sheave clearanceS For example: If belt to sheave clearance is .020 too large, removing one .020 shim will position the movable sheave closer to the fixed sheave reducing belt to sheave clearance by .020
NOTE: The following washers are available for fine tuning:
Washers: PN 5210754 PN 5210753 PN 5210752 0.050 0.032 0.020
4Install spider washer(s) and spider aligning" sNotice as the spider seat location is changed, the sheave marks made before disassembly no longer alignThere are two ways to bring the sheave marks into alignmentS Vary the amount and thickness of spacer washers (Washer thickness may vary slightly)