2004 Polaris Pro X Factory Service Manual, Page 66Get this manual
MAINTENANCE Track Tension Data
Suspension PRO Weight 10 lbs (4.54 kg) Measurement Location 16 ahead of rear idler shaft Measurement 14" 12 (3.173.81 cm
WARNING
When performing the following checks and adjustments, stay clear of all moving parts to avoid serious personal injury
Track Tension
1Turn the machine off2Lift the rear of the machine and safely support it off the ground3Place 10 lb(4.5 kg) weight on the track at point approximately 16 (40.6 cm ahead of the center of the rear idler wheel4Check for proper slack between the track clip wear surface and the hi-fax (C)NOTE: Measure at the point where the weight is hangingIf the track needs adjustment: 5Loosen rear idler shaft bolts (D) on both sides of the machine6Loosen track adjusting bolt locknuts (A)7Tighten or loosen the track adjusting bolts (B) evenly as necessary to obtain proper track tension8Tighten idler shaft bolts and adjuster bolt locknuts