2003 Polaris Deep Snow Snowmobiles Service Manual, Page 222Get this manual
BODY AND STEERING Camber Adjustment
1Determine which spindle requires the greatest amount of correction by installing the alignment bar through one side to the opposite spindleRemove the bar and install it through the other side to the opposite spindle
Measure Here
2Using 38 (1 cm) drive 1116 (1.7 cm) crow foot wrench and 20 (51 cm) long 38 (1 cm) drive extension, loosen the radius rod end jam nutRemove the lower radius rod bolt from the spindle requiring the most camber correctionAdjust the opposite side next3To adjust camber, change upper or lower radius rod length until alignment bar measurement is within specified range for each spindle, and spindle centering dimentions are met, see page 6.6On models with neutral camber (0) the bar should slide freely through both spindlestolerance)CAUTION: Radius rod ends must remain parallel to the bulkhead after rod end jam nuts are tightened to specified torqueSee illustration at right4Tighten all jam nutsTorque radius rod attaching bolts to specificationRod end parallel to mounting surface when jam nut is tightWARNING