2000 Polaris Indy 500 / 600 snowmobile service manual, Page 347Get this manual
BRAKESFINAL DRIVE Mechanical Brake System Mechanical Brake Assembly and Installation to Transmission
1Clip moveable brake pad into position under holder clipHold moveable and stationary pads in place with rubber band while placing assembly over rotor disc and mounting to transmissionRemove rubber bands once system is bolted into place2Apply light coating of RTV silicone to transmission shaftPosition moveable caliper pad assembly along with mounting bracket (Item 6) and brake disc onto transmission as unitSlide disc fully over shaft3Assemble bolts, spring washer, and flat washers to transmission and top mounting bracket (Items 3, 4, 5,6)Finger tighten4Assemble bolts, spacers, and cable bracket to top mounting bracket and moveable caliper pad assembly (Items 18, 7, 2, 6,20)Position stationary caliper pad assembly inside top mounting bracket pushing bolts through stationary assemblyInstall spacers and lock nuts on bolts and torque to specificationCaliper Bolt Torque ftlbs(11 Nm)