2000 Polaris Indy 500 / 600 snowmobile service manual, Page 300Get this manual
SUSPENSION Fox Shock Maintenance Assembly, Cont12Place shop towel over the end of IFP tool and slowly push IFP to specified depthAdd oil so IFP is submerged at least 14
13With the IFP set and the bleeder screw removed, slowly stroke shock to force air through piston orificeMove the shock body slowly to prevent aeration of the oilAllow all air to purge through the bleeder screw hole
14Install the bleeder screw with new O-ring and tighten securely using the flats on the tool to prevent the IFP from turningPour out excess oilIt is not necessary to completely clean all oil from the nitrogen chamber, small amount of oil will lubricate the IFPVerify the proper IFP depth to within .025 (.63mm) with dial caliperBe sure to measure to the flat portion of the IFP, not to the tapered outer edge15Reinstall body cap with new O-ring and tighten by handMount shock with body cap end down in the soft jaws of viseTorque bearing cap to 8-10 ftlbs(11-14 Nm)This will also tighten the body into the body capCAUTION: Do not over tighten or damage to the bearing may result