2000 Polaris Indy 500 / 600 snowmobile service manual, Page 239Get this manual
BODY AND STEERING Seat Cover Replacement 7Turn the assembly over and begin upholstering by lining up the seat cover vinyl side flaps with the indented square location indicators located on the plastic seat base as shown in Ill1ACAUTION: Apply staples in the stapling channel onlySee Ill 1If you apply staples outside the channel, you will damage the fuel tank reservoir in the seat baseIf this happens you must replace the entire seat base assembly8Using staple gun, tack each side of the vinyl cover in place using two staplesIf cover has Polaris emblem carefully align emblem with bottom edge of seatThis will help ensure that the cover is positioned properly9Align the two sewn seams located at the rear of the seat cover with the two back corners of the seat baseSee Ill1Pull the vinyl tight and tack the seat cover to the plastic seat base in each cornerUse two or three staples per corner10Now that the seat cover is correctly positioned, and tacked to the plastic seat base in four places, turn the assembly over and inspect itIf the seat cover seems to fit correctly and everything looks straight, including the tool compartment flap, continue with step 11Bottom View Of Seat Assembly Stapling Channel Tack Cover Here First Location Indicators Staples Sewn Seams Tack Cover Here Second