2000 Polaris Indy 500 / 600 snowmobile service manual, Page 225Get this manual
BODY AND STEERING High Performance CRC Steering Adjustment Camber AdjustmentXTRA CRC and XC-10 CRC, (Cont
8Using 38 drive 1116 (1.7 cm) crow foot wrench and 20 (51 cm) long 38 (1 cm) drive extension, loosen the radius rod end jam nut and remove the lower radius rod bolt from the spindle requiring the most camber correctionAdjust the opposite side nextChange radius rod length until alignment bar slides freely through both spindles9When adjustment is correct, tighten jam nuts to 24-25 ftlbs(33-35Nm)Torque radius rod attaching bolts to 28-30 ftlbs(39-41 Nm)CAUTION: Radius rod ends must remain parallel to the mounting brackets after the rod end jam nuts are tightened to the specified torqueSee illustration at right10Tighten all jam nutsTorque radius rod attaching bolts to specification11Re-check set specificationsup width and compare to Rod end parallel to mounting surface when jam nut is tightRod End Bulkhead Jam Nut