2007 Arctic Cat Four-Stroke Factory Service Manual, Page 501Get this manual
9Move the rear arm assembly rearward far enough to gain access to the front arm mounting bracket lock nuts; then remove the cap screws and lock nuts securing the brackets to the slide rails MS106A
2Install the axle into the lower shock eyelet bushing assembly; then install the two spacers and the two shim washersMS106A
INSPECTING
! NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Inspect all front arm weldments for cracks or unusual bends; then inspect the front arm mounting brackets for cracks and for elongated holes2Closely inspect all tubing for cracks or unusual bends3Inspect the bearings, bushings, and front arm spacers for wear or damage4Inspect the shock absorber for damage and for any signs of oil leakage especially at the point where the shock shaft enters the shock body5Inspect the shock absorber eyelet welds (at each end) for any cracks, signs of separation, or for unthreadingINSTALLING