2007 Arctic Cat Four-Stroke Factory Service Manual, Page 496Get this manual
2Place the outer idler wheels on the axle and secure with two cap screws (coated with blue Loctite #243) and large flat washersTighten cap screws only until snug 2Remove the cap screw and lock nut securing the upper shock eyelet to the idler armAccount for spacer, cap screw, and lock nut
MS024A FC194
! NOTE: It is advisable to tighten the rear idler wheel axle only until snug until the skid frame has been installed and track tension has been adjusted; then the axle assembly must be tightened to specifications
! NOTE: Mark the hole that the upper shock links are mounted in for assembly purposes
3Install the skid frame (see Installing Skid Frame in this sub-section)4Adjust track alignment (see Track Alignment in this sub-section)5Adjust track tension deflection (see Track Tension in this sub-section)MS025