2007 Arctic Cat Four-Stroke Factory Service Manual, Page 478Get this manual
! NOTE: If binding of the wear strip occurs, it may be necessary to use pipe wrench, start from either end, and hook the edge of the wear strip with the pipe wrench jaw and twist the wear strip off the slide railMove the pipe wrench 7.5 cm (3 in and again twist the wear strip off the railRepeat this procedure until the wear strip is free of the rail 3Remove the front arm limiter straps from the front arm of the skid frameMS003B
6Account for flat washer and two spacer washers
4Remove the cap screws securing the two front rail supports to the slide railMS051
7Remove the cap screw and flat washer securing the spring slide to the railAccount for spacer and the slide block