2007 Arctic Cat Four-Stroke Factory Service Manual, Page 477Get this manual
3Position the shock links in the appropriate holes of the idler arm brackets (see Chassis and Skid Frame Mounting Locations in this section)Place spacer (A) between the center of the bracketsInsert the axle links (B) into the upper shock link eyelets; then insert the cap screw with washer through the eyeletsSecure with cap screw, washer, and lock nutTighten securely ! NOTE: It is advisable to install the rear arm springs onto the adjuster blocks after the skid frame has been installed
Slide Rails
! NOTE: The skid frame must be removed for this procedure (see Removing Skid Frame in this subsection)
REMOVING
! NOTE: When it is necessary to replace one or both slide rails, it is recommended that one slide rail be removed at timeThe remaining slide rail will then hold the rail supports, axles, and brackets in their correct assembly orderAlways mark the mounting hole locations during disassembly to speed up the assembly process and to prevent any damageThis method is much quicker than to completely disassemble the entire skid frameTo replace either rail, use the following procedure