2007 Arctic Cat Four-Stroke Factory Service Manual, Page 441Get this manual
! NOTE: The adjusting bolt may have to be loosened to remove the adjuster bushing! NOTE: At this point, the slide rail should be free of the skid frame components and can be removed! NOTE: If applicable, remove the cap screw and lock nut securing the coupler block to the slide rail ! NOTE: The shock pads should be removed only if being replaced
17On the front shock pads (and rear shock pads on the Bearcat WT models) using drill and 3 16-indrill bit, drill out the rivets and remove the shock padsNote the shock pad location for installationAccount for the retaining brackets
16On the Touring models, remove the cap screws and lock nuts securing the track adjuster bracket! NOTE: At this point on the Bearcat WT warticulation, remove the idler wheel; then remove the two cap screws securing the articulating skid frame mounting bracket to the slide rail