2007 Arctic Cat Four-Stroke Factory Service Manual, Page 438Get this manual
! NOTE: It is advisable to install the rear arm springs onto the adjuster blocks after the skid frame has been installed Slide Rails
! NOTE: The skid frame must be removed for this procedure (see Removing Skid Frame in this sub-section)
REMOVING
! NOTE: When it is necessary to replace one or both slide rails, it is recommended that one slide rail be removed at timeThe remaining slide rail will then hold the rail supports, axles, and brackets in their correct assembly orderAlways mark the mounting hole locations during disassembly to speed up the assembly process and to prevent any damageThis method is much quicker than to completely disassemble the entire skid frameTo replace either rail, use the following procedureAG510D
! NOTE: If binding of the wear strip occurs, use pipe wrench, start from either end, and hook the edge of the wear strip with the pipe wrench jaw and twist the wear strip off the slide railMove the pipe wrench 7.5 cm (3 in and again twist the wear strip off the railRepeat this procedure until the wear strip is free of the rail