2007 Arctic Cat Four-Stroke Factory Service Manual, Page 415Get this manual
REMOVING ! NOTE: The shock pads should be removed only if being replaced
1Using 316-indrill bit, drill out the rivets securing each front shock pad (and each rear shock pad on the Bearcat WT) to the slide railAccount for the retaining brackets
2Inspect the end cap for any signs of cracking or wear
2On the Touring models, remove the torx-head screws and lock nuts securing the rear shock pads to the slide rail
3Clean both the slide rail area and the end capUsing compressed air, clean the areas of dirt and gravel
! WARNING
Always wear an approved pair of safety glasses when using compressed air