2007 Arctic Cat Four-Stroke Factory Service Manual, Page 368Get this manual
16Install the toe shield and toe hook bracket; then install the torx-head cap screwsTighten securely17Place the expansion chamber and resonator into position and secure with the springs and the hairpin clip18Adjust track alignment and tension (see Section 9) Brake LeverMaster Cylinder Assembly
(660 cc1100 cc Z1)
739-269C
2Place an absorbent towel around the connection to absorb brake fluidRemove the banjo-fitting bolt (A) securing the brake fluid hose (B) to the master cylinderDiscard the two crush washers
! CAUTION
Brake fluid is highly corrosiveDo not spill brake fluid on any surface of the snowmobile
3Remove the snap ring (C) and pin (D) securing the brake lever to the master cylinder4Using small screwdriver, compress the tabs of the brakelight switch (E) to release it from the master cylinder5Remove the two torx-head screws (F) and clamp securing the brake reservoir to the handlebar; then place towel over the reservoir and remove the assembly from the handlebar0742-152