2007 Arctic Cat Four-Stroke Factory Service Manual, Page 361Get this manual
8Remove the reservoir cover and remove the remaining fluid; then fill the reservoir with fresh fluid9Pump the brake lever to ensure correct positioning of the brake pads; then release10Fill the reservoir to the proper level with fresh brake fluid! NOTE: When new brake pads are installed, "burnishing" process is requiredDrive the snowmobile slowly and compress the brake lever several times until the pads just start to warm up; then allow them to cool downThis procedure stabilizes the pad material and extends the life of the pads ZJ211
5Slide piece of flexible tubing over the ball of the bleeder valve and direct the other end into container
BRAKE CALIPERBRAKE DISC DRIVESHAFT BEARING RemovingDisassembling
1Open the right-side access panel; then remove the springs and hairpin clip securing the resonator to the exhaust pipe and chassisRemove the resonator2Remove the torx-head cap screws securing the toe shield and hook bracket to the chassis; then remove the shield and bracket3Remove the two torx-head cap screws securing the speedometer sensor mounting bracket to the caliper assembly; then disconnect the harness plug-inRemove the sensor and bracket739-269B