2007 Arctic Cat Four-Stroke Factory Service Manual, Page 350Get this manual
! CAUTION It is critical that the two 1.5 mm (0.060 in washers are in place on the input shaft when installing the drain pulley
7Secure the driven pulley with components and hardware as noted in removingTighten to specifications
0742-020
11Install the side panels! NOTE: If the track was loosened to aid in removing the gear case, tighten track to proper tension and alignment
Replacing Driven Shaft PTO-End Bearing
(Bearcat Wide Track Panther 660T660)
8Install the drive belt! NOTE: For installing drive belt, see Removing Installing Drive Belt (ACT Roller Driven Pulley) in this section