2007 Arctic Cat Four-Stroke Factory Service Manual, Page 348Get this manual
11Install the first retaining ring onto the shift fork shaft; then install new oil seal! NOTE: It is advisable to apply film of grease to the oil seal prior to installing
14Apply 18-inbead of Loctite Sealant (pn 1048-059) to the sealing surfaces of the gear case
12With the alignment marks properly positioned, install the shift fork arm to the shaftSecure the arm with the remaining retaining ring
! CAUTION
Care must be taken not to allow silicone sealant into the cap screw holes and dowel pin holes or damage to the gear case may occur when tightening the cap screws