2007 Arctic Cat Four-Stroke Factory Service Manual, Page 340Get this manual
8Using Brake Disc Socket Wrench (pn 0644481), tighten the brake disc retaining nut to specifications ZJ250A
14Install the drive beltMS323
! NOTE: After the retaining nut is tightened to specifications, peen the nut at the flat spot of the driveshaft
! NOTE: For installing drive belt, see Removing Installing Drive Belt (ACT Roller Driven Pulley) in this section
15Place the access panels into position and secure with existing hardware16Check the track for alignment and recommended tension; then tighten the cap screws securely (see Section 9)DISASSEMBLING GEAR CASE
9Secure the driveshaft to the output shaft with the cap screw (coated with blue Loctite #243) and washerTighten to specifications
1Remove the three torx-head cap screws securing the shift actuator to the gear case and remove the actuator; then remove the gear indicator switch