2007 Arctic Cat Four-Stroke Factory Service Manual, Page 326Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 326

Drive TrainBrake Disc (Bearcat Wide TrackPanther 660T660)

! NOTE: On the Bearcat WT non-turbo, Panther 660 models, and T660 Touring if the driven pulley is tight on the driven shaft, pull the driven pulley off using the Driven Pulley Puller (pn 0744-023)On the Turbo models, use Driven Pulley Puller (pn 0644-469)
DISASSEMBLING

1Remove the chain-case drain plug located on the lower back side of the chain case inside the tunnel and drain the chain case lubricant2Open the belt guard3Remove the drive belt! NOTE: For removing drive belt on models with the ACT Roller Driven Pulley, see Removing Installing Drive Belt (ACT Roller Driven Pulley) in this section

4Remove the cap screw and washer securing the driven pulley; then account for and note the position of any alignment washers

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual