2007 Arctic Cat Four-Stroke Factory Service Manual, Page 323Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 323

740-230A
733-912A

CORRECTING OFFSET

! NOTE: The offset must be correct before checking parallelism
1To correct offset, the driven pulley must be moved laterally on the driven shaftRemove the cap screw and washers securing the driven pulley; then remove the driven pulley! NOTE: If the driven pulley is tight on the driven shaft, pull the driven pulley off using the Driven Pulley Puller (pn 0744-023)
2If parallelism is not within specifications, the parallelism must be correctedCORRECTING PARALLELISM

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual