2007 Arctic Cat Four-Stroke Factory Service Manual, Page 319Get this manual
CLEANING AND INSPECTING ! NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Using parts-cleaning solvent, wash grease, drive belt dust, and foreign matter off all components
! CAUTION
Do not use steel wool or wire brush to clean driven pulley componentsA wire brush or steel wool will cause the sheaves to be gouged (thus, the drive belt may not slide properly between sheaves)Decreased performance and possible accelerated drive belt wear will result
2Inspect the rollers for damage, cracks, or wear3Inspect the sheaves for any gouges, cracks, or other damageAlso, inspect threaded areas of sheaves for damaged or stripped threads4Inspect the torque bracket for cracks or damageThe ramp portions of the bracket and caps must be free of gouges and damageMinor scratches may be repaired using #320 grit wet-or-dry sandpaperFS122