2007 Arctic Cat Four-Stroke Factory Service Manual, Page 317Get this manual
5To correct drive belt deflection, washers can be removed or added between the stationary and movable sheaves of the driven pulley! NOTE: If the drive belt deflection is above specifications, the snowmobile will bog and lack power at clutch engagementFor good performance, proper belt deflection is critical ! NOTE: On the turbo models after removing the driven pulley, retrieve the cap screw and washers from inside the pulley bore; then account for and remove any alignment washers along with the spacer and spacer washerThese alignment washers must be used during assemblinginstalling! NOTE: On the Jaguar Z1 after removing the driven pulley, account for the cap screw and washers, sheave adjuster, alignment washers, and Oring from outside the pulley; then from the input shaft, remove the two 1.5 mm (0.060 in washers along with any other alignment washersThese washers must be used during assemblinginstalling
6Secure the belt guard
ACT Roller Driven Pulley
(Jaguar Z1Turbo Models)
REMOVINGDISASSEMBLING