2007 Arctic Cat Four-Stroke Factory Service Manual, Page 315Get this manual
3Secure the driven pulley by installing any alignment washers, the washer, and cap screwTighten the cap screw to specifications 0733-912
! NOTE: The alignment bar must extend beyond the front edge of the drive clutchSC013D
4Check drive clutchdriven pulley alignment (see appropriate Drive ClutchDriven Pulley in this section); adjust as necessary5Install the drive belt and check drive belt deflection (see appropriate Drive ClutchDriven Pulley in this section)Secure the belt guard
4With the bar against the outside edge of the driven pulley stationary sheave at points and B, the bar should just clear the inside edge of the stationary sheave of the drive clutch and rest on the stationary shaftIf the bar does not clear the inside edge or is more than 1.5 mm (0.060 in from the inside edge, the offset must be corrected
(Bearcat Wide Track NonTurboPanther 660 T660 Touring)