2007 Arctic Cat Four-Stroke Factory Service Manual, Page 310Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 310

(Bearcat Wide Track Non-TurboPanther 660 T660 Touring) REMOVING

Driven Pulley

1Open the hood; then open the belt guard2Remove the drive belt3Remove the cap screw and washer securing the driven pulley; then account for and note the position of any alignment washersSC001D

2Place the driven pulley on work fixture so the roller plate is directed upward

4Slide the driven pulley off the driven shaft; then remove pulley from the engine compartment! NOTE: If the driven pulley is tight on the shaft, pull the driven pulley off using the Driven Pulley Puller (pn 0744-023)

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual