2007 Arctic Cat Four-Stroke Factory Service Manual, Page 308Get this manual
3Remove the cam arm pin lock nuts; then using small torch, apply heat to the cam arm set screws to loosen the Loctite used in assembly 4Inspect the cam arm pins for wear or bends5Inspect the spring for proper compression rate qualities (see Drive System Components in this section)6Inspect rollers for damage or wearAssembling
1With the head of each cam arm pin positioned towards the direction of the drive clutch rotation, install the cam arms! NOTE: The drive clutch rotates counterclockwiseFS001
! NOTE: Heat must be applied to the cam arm in order to remove the set screws
2With the cam arm pin properly positioned, apply green Loctite #620 to the set screw holes in the cam arm, install the new set screws (pre-coated with Loctite), and tighten securely
4After the lock nuts and set screws have been removed, remove the cam arm pins one at time noting the position of the alignment notches for assembly purposesAccount for the O-rings
739-040A
! CAUTION