2007 Arctic Cat Four-Stroke Factory Service Manual, Page 281Get this manual
(Bearcat Wide TrackJaguar Z1 Panther 660T660) ! NOTE: Some components may vary from model to modelThe technician should use discretion and sound judgment
Seat Cushion
Touring
REMOVING
1Remove the gas tankseat assembly (see appropriate Gas TankSeat Assembly in this section)2Remove the two screws securing the taillight cover; then remove the cover3Remove the two screws securing the front of the seat cushion to the seat base4Using sharp tool, pry out all staples securing the seat cover to the plastic seat baseRemove the cover from the seat base and seat foamINSTALLING
! NOTE: If the seat cover was removed, position the cover over the seat foam and plastic seat baseCheck to make sure it is positioned straight; then fold the rear edge of the cushion down and around the baseUsing staple gun and mm (14 in staples, staple the rear flap of the cushion to the base in the same areas as the original staples were locatedPosition staples 2.5 cm (1 in apartFold the sides of the cushion down around the bottom edge of the basePosition the staples in the same areas as the original staples were located