2007 Arctic Cat Four-Stroke Factory Service Manual, Page 278Get this manual
9Compress the clip on the gasline hose connector and remove the hose from the gas tank; then disconnect the gas tank vent hose and close off the vent hose outlet of the gas tank and remove the gas tank0741-965
3Remove the two torx-head cap screws (B) securing the handlebar close-off panel; then remove the three torx-head cap screws (C) securing the rear side panels (spars) to the seat support tubes4Remove the two screws (D) securing the knee pads to the gas tank; then remove the remaining body screws securing the knee pads to the steering support5Adjust the seat to the lowest position; then while lifting on the top forward part of the seat, remove the machine screw (E) from the right side of the seat support assemblyRemove the seat6Remove the four cap screws (F) securing the support tubes to support plate7Remove the six torx-head screws (G) securing the seat support assembly to the tunnel; then slide the support back out of the way