2007 Arctic Cat Four-Stroke Factory Service Manual, Page 260Get this manual
INSTALLING LOWER A-ARM
1If removed, install new split bearings onto the shaft of the lower A-arm; then using suitable pliers, evenly compress the bearing until it is properly fitted to the shaft2Install the lower A-arm into the sway bar link and with the axles properly installed as noted in removing, place the arm into position in the chassis0742-219
7Remove the cap screws and lock nuts securing the lower A-arm to the chassis; then remove the arm from the sway bar and chassis and account for the axles! NOTE: For installing purposes, note the position of the axle shoulders
! NOTE: When installing the lower A-arm, position the shock absorber to the inside of the spindle axle before securing the arm to the chassis
3Install the cap screws and lock nuts securing the A-arm to the chassis; then tighten to specificationsZJ168A