2007 Arctic Cat Four-Stroke Factory Service Manual, Page 255Get this manual
! NOTE: Repeat this procedure on each side (if necessary) until ski toe-out is within specification 2Remove the spindle (see appropriate Spindle in this section)! NOTE: The ski does not have to be removed from the spindle for this procedure
! WARNING
Neglecting to lock the tie rod by tightening the jam nuts may cause loss of snowmobile control and possible personal injury
VERIFYING
3Remove the cap screw and lock nut securing the upper shock eyelet to the upper A-arm; then remove the shockAccount for two shock bushings
1With the handlebar in the straight-ahead position, verify ski alignment by measuring across from the outside edge of the left-side wear bar bolts to the outside edge of the right-side wear bar bolts (without using the straightedge) in two places: approximately 18-20 cm (7-8 in in front of the spindle and 18-20 cm (7-8 in behind the spindle2The measurement from in front of the spindle to the outer edge of the wear bar bolts (without using the straightedge) must not exceed the rear measurement by more than 1.6-6.4 mm (116-1 in toe-out