2007 Arctic Cat Four-Stroke Factory Service Manual, Page 253Get this manual
3If ski alignment is not as specified, the snowmobile will have tendency to wander and may be difficult to control; therefore, an adjustment is necessaryADJUSTING
1Make sure the ignition key is in the OFF position2Visually examine the skis to determine which ski is out of alignment with respect to the handlebar0734-407
3Open the hood and loosen the jam nut on each end of the tie rod4While holding the straight ski in position, rotate the tie rod until the measurement between the skis is within specifications5When the ski alignment is correct, apply blue Loctite #243 to the jam nut threaded areas and tighten each jam nut securely against the tie rod
! NOTE: With the exception of the Jaguar Z1 if the handlebar is not in the straight-ahead position when the hole in the middle of the drag link aligns with the notch in the chassis, the steering tie rod must be adjustedWhen handlebar alignment is correct, apply blue Loctite #243 to the jam nut threaded area and tighten to specificationsTighten both jam nuts against the steering tie rod