2007 Arctic Cat Four-Stroke Factory Service Manual, Page 251Get this manual
INSTALLING
1Position the handlebar in the straight-ahead position; then position the skis straight ahead2Thread the jam nuts onto the ball joints; then equally thread the ball joints onto the steering tie rod! NOTE: There must be an approximate equal number of threads exposed on each ball joint
3Place the tie-rod assembly into position; then rotate the steering tie rod until the holes in the ball joints align with the holes in the steering post and steering arm4Ensure correct handlebarski alignment (adjust steering tie rod as necessary); then apply blue Loctite #243 to the jam nut threaded area and tighten to specifications5Secure the tie-rod assembly with the two cap screws (coated with green Loctite #609) and lock nutsTighten to specifications; then install the cotter pins and spread the cotter pins
Steering Tie Rod
(Jaguar Z1) REMOVING