2007 Arctic Cat Four-Stroke Factory Service Manual, Page 242Get this manual
2Remove the tie rod from the steering post (see steps 10-12 of Steering Post (120 cc)Removing sub-section)3Loosen the jam nuts securing the tie rod; then remove the ball joints from the tie rodSlide the tie rod from the steering bootCLEANING AND INSPECTING ! NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Secure the steering post to the front end (see steps 3-5 of Steering Post (120 cc)Installing sub-section)4Secure the outer tie rod to the spindle with lock nut (coated with green Loctite #609)Tighten to specifications
1Inspect the ball joints and tie rods for damaged threads or wear2Inspect the ball joints and tie rods for cracks or unusual bends3Wash the ball joint in parts-cleaning solventDry with compressed airInspect the ball joint pivot area for wearApply low-temperature grease to the ball jointZJ296A
! NOTE: The ball joint must be installed on the bottom side of the spindle arm
! WARNING
Always wear safety glasses when using compressed air
5Lock the jam nuts against the tie rod; then adjust ski alignment (see appropriate Ski Alignment in this section)