2007 Arctic Cat Four-Stroke Factory Service Manual, Page 239Get this manual
Panther 660
4Install the MAG-side rubber engine mount to the chassis with the two cap screws (coated with blue Loctite #243)Tighten cap screws to specificationsInstall the cap screw (coated with blue Loctite #243) securing the engine mount bracket to the rubber engine mountTighten cap screw to specifications5Place the steering boot into position on the front endSecure with self-tapping screws6Install the tie rods (threaded area coated with green Loctite #609) on the spindle arms as noted during removingSecure with O-rings, washers, and lock nutsTighten to specifications
KEY 1Drag Link 2Bearing 3Steering Arm Assy 4Insert 5Idler Arm 6Cap Screw 7Lock Nut
89101112131415
Cap Screw Axle Washer Lock Nut Cap Screw Washer Lock Nut Washer
161718192021
O-Ring Ball Joint (RH) Hex Nut (RH) Tie Rod Tube Hex Nut (LH) Ball Joint (LH)
0738-354