2007 Arctic Cat Four-Stroke Factory Service Manual, Page 220Get this manual
Testing Thumb Warmer Element (HIOFFLO Function)
! NOTE: During this test, resistance will vary due to temperature; therefore, this test should be made at room temperature of 20 (68F)
1Remove the handlebar pad; then disconnect the thumb warmer three-wire connectorAF909D
INSTALLING
2In the element connector, connect one ohmmeter lead to the greenwhite lead; then connect the other ohmmeter lead to the green lead3The meter must read between 1.5 and 6.9 ohms4In the element connector, connect one ohmmeter lead to the greenblack lead; then connect the other ohmmeter lead to the yellow lead5The meter must read between 5.5 and 23.0 ohms! NOTE: If either test is not within specification, replace the thumb warmer element
1Place the dimmer switch into the control and secure with the cover plate and screws2Connect the four-prong plug; then install and secure the handlebar pad
Testing Handlebar Warmer Elements