2007 Arctic Cat Four-Stroke Factory Service Manual, Page 218Get this manual
Brakelight Switch TESTINGREMOVING
! NOTE: On the Jaguar Z1 to access the brakelight switch connector, the two rear console screws must be removed and the console must be lifted upward and forward
1Disconnect the brakelight switch black and brown two-wire connector (located below the steering support)
4To remove the switch, remove the snap ring; then remove the pin securing the brake lever to the control assembly5Using small flat-blade screwdriver, compress the tabs of the switch; then push the switch toward the end of the handlebar and out of the control assembly