2007 Arctic Cat Four-Stroke Factory Service Manual, Page 215Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 215

0742-002

INSTALLING

1Place the magneto into position on the cover; then install and tighten the three cap screws to specificationsWith the harness routed properly, install the timing sensor and harness clamp and tighten to 1.0 kg-m (7 ft-lb)
3Install the two alignment pins in the engine for the magneto cover; then with new gasket, install the cover and with the pattern shown, tighten the 18 cap screws to 1.0 kg-m (7 ft-lb)
741-583A

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual