2007 Arctic Cat Four-Stroke Factory Service Manual, Page 208Get this manual
4With suitable driving tool, install new seal into the bearing housing; then install the bearing housing! NOTE: Prior to installing the bearing housing, position the locking plate with the tabs (A) of the locking plate aligned with the cap screw ears (B) of the starter motor
2Install the starter motor to the engine and secure with the two cap screws (coated with blue Loctite #243)Tighten to 1.0-1.4 kg-m (7-10 ft-lb)
3Install the driven pulley; then install the drive beltZJ144A
5Install the two long cap screws securing the starter motor together; then tighten the cap screws to 1.0-1.4 kg-m (7-10 ft-lb)