2007 Arctic Cat Four-Stroke Factory Service Manual, Page 204Get this manual

2007 Arctic Cat Four-Stroke Factory Service Manual, Page 204


DISASSEMBLING (1100 cc Z1)

1Secure the starter motor in suitable clamping device; then remove the two long cap screws from the starter motor
4With the armature removed from the magnet housing, remove snap ring (D) from the armatureAccount for shim (E) and locking plate (F)5Using flat-blade screwdriver, carefully remove the seal from the bearing housingZJ140A ZJ142A

2For assembling purposes, make alignment marks on the bearing housing, magnet housing, and brush assembly

Back to 2007 Arctic Cat Four-Stroke Factory Service Manual