2007 Arctic Cat Four-Stroke Factory Service Manual, Page 202Get this manual
(660 cc1100 cc Z1) REMOVING (660 cc)
Starter Motor
1Remove the drive belt; then remove the driven pulley! NOTE: On turbo models to remove these components, proceed to RemovingInstalling Drive Belt (ACT Roller Driven Pulley); then proceed to ACT Roller Driven Pulley (Turbo Models) in Section of this manual
DISASSEMBLING (660 cc)
2Remove the two cap screws securing the starter motor; then remove the starter motor
1Remove the solenoid nut securing the starter wire strap to the solenoidPull the wire strap away from the cap screws securing the solenoid to the starter motorMD1437