2007 Arctic Cat Four-Stroke Factory Service Manual, Page 182Get this manual
0735-459
3Pull all slack from the throttle cable wire and exert slight tension on the wire4Tighten the throttle cable wire binding screw! NOTE: The speed control screw is designed to reduce the maximum speed of the snowmobile
! WARNING
DO NOT operate the snowmobile when any component in the throttle system is damaged, frayed, kinked, worn, or improperly adjusted
3Place the throttle cable into the throttle cable bracket and secure with jam nuts4Slide the tip of the throttle cable into the throttle actuator and tighten the binding screw5Secure the throttle cable to the steering post with cable tie; then install the handlebar pad! NOTE: At this point, spray the binding screw drum (located on the carburetor throttle arm) with WD-40 or an equivalent lubricant