2007 Arctic Cat Four-Stroke Factory Service Manual, Page 155Get this manual
! NOTE: It is advisable to apply heat to the housing to aid in removing the bearing ! NOTE: It is advisable to apply light coat of grease on the O-ring to aid in keeping it properly positioned
! CAUTION
Care should be taken not to apply too much heat to the housing or the bushing next to the bearing may be damaged
6Secure the housings with the two Phillips-head screws (A); then tighten the screws with an impact driver
5Clean the inner and outer housings with partscleaning solvent; then dry with compressed air
! CAUTION
Care should be taken not to over-tighten the screws with the impact driver or damage to the housings may occur
! WARNING
Always wear safety glasses when drying components with compressed air
INSTALLING