2007 Arctic Cat Four-Stroke Factory Service Manual, Page 147Get this manual
! NOTE: To finalize this procedure, it is necessary to install the air silencerProceed to Servicing Air Silencer (1100 cc Z1) sub-section and follow steps 3-12 of INSTALLING Ignition Timing
! NOTE: Before starting this procedure, the engine must be at operating temperatureZJ094A
23Install and secure the throttle bodies to the intake flanges with the flange clamps; then secure the wiring harness to the fuel rail with cable ties as noted during disassembling
1Verify the engine idle speedThe idle speed specification is 1100 RPM 100 RPM2Remove the air silencer (see appropriate Servicing Air Silencer in this section)3Remove the two cap screws, one lock nut, and washer securing the alternatorwater pump belt cover4Remove the fuse block cover and locate the diagnostic plug; then install the jumper wire to the connections marked TS and GND terminals