2007 Arctic Cat Four-Stroke Factory Service Manual, Page 109Get this manual
AO188 739-267B
! NOTE: By bottoming the sheave adjuster against the driven shaft, the sheaves at the driven pulley will spread far enough to allow the installation of the drive belt
! NOTE: On turbo models, install the intercooler bracket onto the engine; then tighten the two flange nuts securely
21Install the air silencer bracket to the engine and secure with the lock nut22Connect the lower drain hose to the outlet at the bottom of the belly pan23On the non-turbo models, install the air silencer (see appropriate Servicing Air Silencer in Section 3)
BPlace the drive belt (so the part number can be read) between the sheaves of the drive clutch first; then between the sheaves of the driven pulleyCUsing the deflection tool, remove the sheave adjuster from the end of the driven pulleyDPlace the shim washers and O-ring (as noted in removing) onto the sheave adjuster; then carefully thread the sheave adjuster back into the driven pulleyTighten the adjuster securely using the deflection toolEClose the belt guard; then install the driven pulley plug18With the two plastic collars, belt guard pin, and the hairpin clip, secure the belt guard in place19Connect the fuel hose and throttle body heater hose to the throttle body and secure with the hose clamps20Connect the fuel hose to the fuel filter and the throttle body heater hose to the main return coolant hose