2007 Arctic Cat Four-Stroke Factory Service Manual, Page 104Get this manual
44Install the oil scavenge pump alignment pins in the engine case; then with the inner and outer seals (A) in place on the pump, install the pump and secure with the four cap screws (B)Tighten to specifications ! NOTE: If the water temperature and oil pressure sensors were removed, install the sensors and tighten in the following sequence: (A) water temperature sensor to 2.1 kg-m (15 ft-lb) and (B) oil pressure sensor to 1.4 kg-m (10 ft-lb)
0742-125
45With the two pins installed in the engine case, first install the starter torque limiter (A) and spacer (B); then install the inner spacer (C), idler gear (D), and outer spacer (E)